Thanks to numerous improvements the new HELIX DSP PRO MK2 raises the bar to a new level, not only in terms of sound quality. Besides the extremely powerful 64 Bit Audio DSP, cutting-edge DA and AD converters with an incredible native resolution of 32 Bit ensure unparalleled sound characteristics.
The improved internal power supply as well as the increased maximum output voltage of 8 Volts contribute to the enhanced sound quality of this stunning processor. Further innovations like the ADEP circuit (Advanced Diagnostics Error Protection) in the highlevel input for circumventing factory-made loudspeaker diagnostic systems, the Auto Remote switch for activating / deactivating the automatic turn-on feature of the highlevel input and the software-controlled switch between the optical and coaxial input have been added. Of course, the HELIX DSP PRO MK2 provides a HELIX Extension Card slot (HEC slot) for additional input and output modules like Bluetooth® Audio Streaming or the new USB-audio interface. In terms of design, the DSP PRO MK2 shows up with the HELIX-like clean look and offers perfect preconditions for a fast and simple integration. But not only the hardware has been improved the software as well has been completely revised.Features like the allpass filter option, the increased adjustment range of the time alignment and the switchable sound options of the DA converters are solely a few examples. Despite its extended feature set the configuration of the DSP couldn't be easier thanks to the new DSP PC-Tool V4, which leaves nothing to be desired due to its numerous sound optimization options. No doubt - the HELIX DSP PRO MK2 will again make dreams of the most ambitious sound enthusiasts come true - that´s a safe bet! FEATURES: Extremely powerful fixed point Audio DSP with 64 Bit resolution and 1.2 billion MAC operations per second AD and DA signal converters of the latest generation with a native resolution of 32 Bit High Resolution audio bandwidth up to more than 40 kHz for unrivalled sound quality HELIX Extension Card slot (HEC) for additional input / output modules like Bluetooth® Audio Streaming Smart highlevel input with ADEP circuit (Advanced Diagnostics Error Protection) Start-Stop capability down to 6V supply voltage Freely definable signal routing with separate matrices for line, SPDIF and HEC/AUX Ground lift switch to avoid ground loops Control input for connecting remote controls and accessories Time alignment with up to 20 ms delay time per channel, additionally reverse time alignment for in-phase summation of the inputs Inputs: 8 x RCA/Cinch, 8 x Highlevel, 1 x optical SPDIF and 1 x coaxial SPDIF Outputs: 10 x RCA/Cinch with max.
8 Volts output voltage Special features: 96 kHz sampling rate The HELIX DSP PRO MK2 allows to handle all signals with the doubled sampling rate of 96 kHz. Thus the audio bandwidth is no longer limited to usual values like 22 kHz but allows an extended frequency response to more than 40 kHz. Doubling the sampling rate requires significantly higher DSP power as the number of possible arithmetic operations is halved. Only the implementation of the latest DSP chip generation allows raising the sampling rate to 96 kHz and adding new features plus additional channels at the same time.
Signal converters with a native resolution of 32 Bit The HELIX DSP PRO MK2 uses high-class AD and DA converters of the latest generation with a native resolution of 32 Bit instead of the common 24 Bit. The result is an unprecedented precision in signal conversion that especially optimizes the sound quality at lower signal levels. Smart highlevel input The latest generation of OE car radios incorporates sophisticated possibilities of diagnosing the connected speakers. If a common signal processor will be hooked up failure messages and loss of specific features e.
Fader function quite often appears - but not with the DSP PRO MK2. The new ADEP circuit (Advanced Diagnostics Error Protection) avoids all these problems without loading the speaker outputs of the OE radio during high volumes unnecessarily. Start-Stop capability The switched power supply of the HELIX DSP PRO MK2 assures a constant internal supply voltage even if the batterys voltage drops to 6 Volts during engine crank.
Power Save Mode The Power Save Mode is incorporated in the basic setup. It allows to significantly reduce the power consumption of the amplifiers that are connected to the HELIX DSP PRO MK2 once theres no input signal present for more than 60 seconds.Please note that in many up-to-date cars with CAN or any other internal bus structures it may happen that the radio remains invisibly turned on for up to 45 min. Even after locking and leaving the car! Once the Power Save Mode is active the remote output and therefore the connected amplifiers will be turned off. The HELIX DSP PRO MK2 will reactivate the remote output within a second if a music signal is applied. It is possible to either modify the turn-off time of 60 sec. Or completely deactivate the Power Save Mode via the DSP PC-Tool software. Automatic Digital Signal Detection Switching from analog input to one of the digital inputs is done automatically as soon as a signal is detected on the Optical Input or Coax Input.
This feature can be deactivated in the DSP PC-Tool software. Alternatively you can use an optional remote control for manual switching between analog and digital inputs. SPECIFICATION Inputs: 8 x RCA / Cinch 8 x Highlevel speaker input 1 x Optical SPDIF (12 96 kHz) 1 x Coax SPDIF (12 - 192 kHz) 1 x Remote In Input sensitivity: RCA / Cinch 2 - 4 Volts Highlevel 5 - 10 Volts or 10 - 20 Volts Outputs: 10 x RCA / Cinch 1 x Remote Out Output voltage: 8 Volts RMS Frequency response: 10 - 44,000 Hz DSP resolution: 64 Bit DSP power: 295 MHz 1.2 billion MAC operations per second Sampling rate: 96 kHz Data converters: A/D: Asahi Kasei 32 Bit D/A: Analog Devices 32 Bit Signal-to-noise ratio (A-weighted): 116 dB (digital input) 110 dB (analog input) Distortion (THD+N).90 dB Power supply: 9.6 - 18 Volts 5 sec. Down to 6 Volts Additional features: HEC slot, Ground lift switch, Control Input, ADEP circuit, Auto Remote switch Dimensions (H x W x D): 40 x 177 x 150 mm / 1.58 x 6.97 x 5.91 INCLUDES. With the new remote control DIRECTOR you lead from the front! Furthermore it provides sufficient memory for 20 additional sound setups and comes with a USB connector allowing straight access to your DSP device via the DIRECTOR - a big relief if you want to tweak your configuration while your processor/amplifier is hidden somewhere in the trunk. The high-resolution colour touchscreen is embedded in an exclusive solid aluminium housing. The DIRECTOR is compatible with all DSP products which are supported by DSP PC-Tool Version 3.
HEC HD AUDIO/USB INTERFACE CONNECT YOUR SMARTPHONE OR ANY UNIT WITH MUSIC PLAYER AND USB AUDIO OUTPUT TO LISTING YOUR FAVOURITE MUSIC THROUGH DSP MINI The HD-AUDIO USB-INTERFACE extends HELIX devices with a High Resolution Audio USB input and converts a PC or smartphone into a HD-Audio player. The direct digital signal transmission (without additional AD-DA conversion) from the music source to the DSP with up to 192 kHz / 32 Bit allows lossless audio processing and thus assures perfect sound quality. A MiniUSB wire is needed for most configurations.For Android devices an additional MicroUSB OTG cable is required. For Apple devices an additional Camera Connection kit or a Lightning to USB cable is required. Attention: The HD-AUDIO USB-INTERFACE does not support charging. SPECIFIATION: Input sampling rate: 32 kHz to 192 kHz / 16 Bit, 24 Bit or 32 Bit Input format: PCM Supported device operating systems: Windows, macOS, iOS, Android Additional features: Asynchronous USB connection with own clock generators for highest jitter immunity. INCLUDES: - PROCESSOR HELIX DSP PRO MK2 IN ORIGINAL BOX - USB LEAD - MOUNTING SCREWS, MANUAL - HELIX DIRECTOR IN ORIGINAL BOX - USB LEAD - CONNECTION CABLE.
HELIX HEC HD-AUDIO USB-INTERFACE - ORIGINAL BOX, MANUAL - SIDE PANEL. The item "HELIX DSP PRO MK2 HIGH-END + DIRECTOR REMOTE CONTROL + HEC HD-AUDIO USB MODULE" is in sale since Saturday, June 29, 2019. This item is in the category "Consumer Electronics\Vehicle Electronics & GPS\Car Audio\Signal Processors". The seller is "audio_for_fun" and is located in Schrattenberg bei Poysdorf. This item can be shipped to United States, all countries in Europe, all countries in continental Asia, Canada.